- Categories
- Multi-copter Set
- Multi-copter controller
- Multi-copter Frame Kit
- Multi-copter Propeller
- Multi-coper Cam Gimbal
- Multi-copter ESC
- Multi-copter Motor
- DIY Accessory
- Spare Parts
- FPV Wireless System
- Flybarless/Gyro system
- RC Airplane
- RC Helicopter
- Helicopter Blades
- Plane Blades/Propeller
- RC Boat
- RC Car
- Servo
- Battery
- Radio Control System
- Balance Charger
- Wire/Line/Silicone Wire
- 3K Carbon Fiber
- Photography Equipment
- Screws/Nuts/Washer
- Adhesive Tapes
Recently Viewed
- Description
- Shipping Methods
-
6pcs SG-5010 Standard High Speed TowerPro Torque Coreless Servo for RC Helicopter Car
These servos utilize the best in surface mount and direct attachment technology, with the motor and feedback pot being directly mounted to the pc board! Most of the cheaper competitive servos use wiring for these connections, and it is a primary point of failure for those cheap look-alikes. These servos also have a unisex connector & electronics that are compatable with JR, Futaba, Hitec, Spektrum, Parkzone, GWS, and most other receivers. They come supplied with servo arms, servo wheels, servo arm screws, rubber mounts, brass eyelets, and servo mounting screws! They have a FAST 3 pole motor, a Ball Bearing supported output shaft, and a 11-1/2" LONG servo lead.
Compared to, but faster / stronger / lighter / less expensive than:
- GWS S09HPX
- HiTec HS-422
- Futaba S3004
- JR - 531
SPECS:
- Size: 1-9/16" L x 25/32" W x 1-1/2" H (41mm L x 20mm W x 38mm H)
- Weight: 1.4 oz (37g)
- Operation Voltage: 4.0V - 6.0V
- Connector Wire Length: 11.5" (292mm)
- Operating Speed: (4.8V/6.0V): 0.20sec/60 degrees, 0.16 sec/60 degrees
- Stall Torque : 72.2 oz/in (5.2 Kg/cm) @ 4.8v, 91.0 oz/in (6.5 Kg/cm) @ 6.0v
- Temperature Range: -22 F to 140 F (-30 C to +60 C)
- Gear type: Nylon Gear & Ball Bearing Output Shaft
- GWS S09HPX
Write Your Reviews
Have any question or inquire for this item? Please contact Customer Service. (Our customer representative will get back shortly.)
