APM2.6 2.5 2.52 APM Power Module with XT60 connectors W/O BEC for ArduPilot Mega 2.5

APM2.5 Power Module is for detecting the battery voltage and battery current, flight controlboard receives two signals to calculate the remaining battery power, estimate the remaining flight time. We also have: http://www.soodohobby.com/ArduPilot-Airplane-Multicopter-Flight-controller-with-GPS-APM-2-5-2-ArduPilot-Mega-2-5-Multicopter-Flight-Control-Board-with-6M-GPS-Module-with-protect-Case_g.ht

APM2.5 Power Module Introduction:

•  APM2.5 Power Module is special for ArduPilot Mega 2.5 is a simple way of providing your APM 2.5 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable.The on-board switching regulator outputs 5.3V and a maximum of 2.25A from up to a 4S LiPo battery. This Power Module comes completely assembled with Deans connectors, and wrapped in shrink tubing for protection. 
• Note: The Power Module is only designed to power APM, a RC receiver and APM accessories (GPS, 3DR radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.

APM2.5 Power Module Technical Specifications:

• Max input voltage: 18V
• Max current sensing: 90A
• Voltage and current measurement configured for 5V ADC
• Switching regulator outputs 5.3V and 2.25A max
• 6-pos DF13 cable plugs directly to APM 2.5's 'PM' connector
• Connectors: DEANS-T type

Connecting it to the APM 2.5 Board 

The 6-pos cable plugs into the 6-pos connector on both the Power Module and APM.

• Your battery connects to the Power Module’s male connector, and its female connector plugs into your ESC or Power Distribution Board.

 APM2.5 Power Module Package Included:

•  APM2.5 Power Module * 1 (BEC excluded)