- Categories
- Multi-copter Set
- Multi-copter controller
- Multi-copter Frame Kit
- Multi-copter Propeller
- Multi-coper Cam Gimbal
- Multi-copter ESC
- Multi-copter Motor
- DIY Accessory
- Spare Parts
- FPV Wireless System
- Flybarless/Gyro system
- RC Airplane
- RC Helicopter
- Helicopter Blades
- Plane Blades/Propeller
- RC Boat
- RC Car
- Servo
- Battery
- Radio Control System
- Balance Charger
- Wire/Line/Silicone Wire
- 3K Carbon Fiber
- Photography Equipment
- Screws/Nuts/Washer
- Adhesive Tapes
![BGC2.3 Rocker1.2 Handheld Brushless DSLR Gimbal Stabilizer Controller Thumb Button for Alexmos [ROCKER12]](/goods_images/s/BGC2-3-Rocker1-2-Handheld-Brushless-DSLR-Gimbal-Stabilizer-Controller-Thumb-Button-for-Alexmos-ROCKER12.jpg "BGC2.3 Rocker1.2 Handheld Brushless DSLR Gimbal Stabilizer Controller Thumb Button for Alexmos [ROCKER12]")
- Home
- Multi-coper Cam Gimbal
- Gimbal Brushless Controller
- BGC2.3 Rocker1.2 Handheld Brushless DSLR Gimbal Stabilizer Controller Thumb Button for Alexmos [ROCKER12]
![BGC2.3 Rocker1.2 Handheld Brushless DSLR Gimbal Stabilizer Controller Thumb Button for Alexmos [ROCKER12]](/goods_images/l/BGC2-3-Rocker1-2-Handheld-Brushless-DSLR-Gimbal-Stabilizer-Controller-Thumb-Button-for-Alexmos-ROCKER12.jpg)
- Description
- Shipping Methods
-
BGC2.3 Rocker1.2 Handheld Brushless DSLR Gimbal Stabilizer Controller Thumb Button for Alexmos [ROCKER12]
Notes: for the BGC2.3 Simple Rocker0.9 Extension Board Module, you can choose from here: http://www.soodohobby.com/BGC2-3-Simple-Rocker0-9-Extension-Board-Module-for-Handheld-Brushless-Gimbal-Photography-for-Alexmos-ROCKER09_g.htmlThis is a 2CH PMW output module,you can cantrol the DSLR Handle Brushless Gimbal Stabilizer Pitch or Roll
Features:
- 2 channel PWM output
- PWM1 for PITCH controller output
- PWM2 for Roll controller output
- Special for DSLR Handle Brushless Gimbal Stabilizer
- PWM1,PWM2, 5V,GND,R,TDisplay Module:
Red LED: Power indicator
Green LED: IIC status indicator, if IIC in normal, green lights, if abnormal, green flashes
Blue LED: On status indicator
Function Module:
3-phase switch
A: PWM output mode
B: Serial port output mode
C: None
Button: ACC
Controller Module: Control gimbal BGC Pitch and Roll by an omnidirection rocker
Port:
PWM1 is rocker Y-axis output
PWM2 is rocker X-axis output
Could connect on BGC A0, A1, A2, A3
5V, GND, RX, TX is serial port output interface(need BGC2.3 firmware)
Write Your Reviews
Have any question or inquire for this item? Please contact Customer Service. (Our customer representative will get back shortly.)
