- Categories
- Multi-copter Set
- Multi-copter controller
- Multi-copter Frame Kit
- Multi-copter Propeller
- Multi-coper Cam Gimbal
- Multi-copter ESC
- Multi-copter Motor
- DIY Accessory
- Spare Parts
- FPV Wireless System
- Flybarless/Gyro system
- RC Airplane
- RC Helicopter
- Helicopter Blades
- Plane Blades/Propeller
- RC Boat
- RC Car
- Servo
- Battery
- Radio Control System
- Balance Charger
- Wire/Line/Silicone Wire
- 3K Carbon Fiber
- Photography Equipment
- Screws/Nuts/Washer
- Adhesive Tapes
- Home
- Multi-coper Cam Gimbal
- Brushless Camera Gimbal
- FY MINI 3D FEIYU MiNi 3D 3-Axis Brushless Gimbal For Aircraft designed for GoPro4,GoPro3+, GoPro3 and other cameras in similar sizes.
- Description
- Shipping Methods
-
The Feiyu MiNi 3D 3-Axis Brushless Gimbal ( For aircraft ) is specially designed for GoPro4,GoPro3+, GoPro3 and other cameras in similar sizes.
The Feiyu MiNi 3D 3-Axis Brushless Gimbal can be easily mounted on fixed wings, multirotors, helicopters for aerial photography, and can work independently only need power supply. You can assemble the gimbal properly according to the drawing, and then install the video camera on it.
There is no need to set up and adjust the parameter. For the first use, power on the Gimbal, and then keep it static for a while, after its reset, the gimbal will be in a level position automatically. Then you can use it normally.
Please put on the camera before powering on the gimbal, or it will not work normally and may cause the gimbal damagedIntroduction
MiNi 3D 3-Axis Brushless Gimbal ( For aircraft ) suitable for GoPro4,GoPro3+,GoPro3 or cameras with similar size. Can be easily mounted in fixed wing, multirotor, helicopter for aerial photography, and can work independently only need power supply.
There is no need to set up and adjust the parameter. For the first use, power on the Gimbal, and then keep it static for a while, after its reset, the gimbal will be in a level position automatically. Then you can use it normally.
Mode Selection
When connect to RC receiver it can switch in 3 working modes, also can control the heading and pitch via the RC receiver.
● Heading Follow Mode —— Camera Pitch and Roll angles remain constant, heading follows the nose position,pitch can be control by RC
● Heading And Pitch Follow Mode ——Camera Roll angle remains constant. Heading follow the nose position and Pitch follow the elevation of the aircreft.
● Heading Lock Mode ——Heading, Pitch and Roll are all locked to point at one position. Heading and pitch can be control by RC
Write Your Reviews
Have any question or inquire for this item? Please contact Customer Service. (Our customer representative will get back shortly.)
